Conversation

Notices

1. Embed this notice
   givenup (givenup@poa.st)'s status on Wednesday, 25-Dec-2024 04:34:18 JST givenup
   i wish i knew what was wrong with my truck
   the auto tranny just don't wanna shift sometimes
   it just gets stuck
   i forced it into second gear to get home
   but it won't leave second gear
   • Embed this notice
     givenup (givenup@poa.st)'s status on Wednesday, 25-Dec-2024 04:34:16 JST givenup

     in reply to

     • DurpState
     @DurpState yea, stepdad says it's a little brown so it should be changed, cuz it's supposed to be red
     BowserNoodle ☦️ likes this.
   • Embed this notice
     DurpState (durpstate@poa.st)'s status on Wednesday, 25-Dec-2024 04:34:17 JST DurpState

     in reply to
     @givenup did you check the transgender fluid?
   • Embed this notice
     BowserNoodle ☦️ (bowsacnoodle@poa.st)'s status on Wednesday, 25-Dec-2024 04:37:58 JST BowserNoodle ☦️

     in reply to

     • DurpState
     @givenup @DurpState Change it, drive a few miles, then change it again. You usually only get ≈½ of the gender fluid out after each swap. So it will be only 25% impure after two changes. Usually best to change it when it's hot. Make sure it doesn't look milky, since that means water.
   • Embed this notice
     givenup (givenup@poa.st)'s status on Wednesday, 25-Dec-2024 06:32:33 JST givenup

     in reply to

     • BowserNoodle ☦️
     • DurpState
     • EnnaComa
     @EnnaComa @BowsacNoodle @DurpState the transmission actually needs rebuilt anyways or replaced, but finding a replacement is pretty impossible we've looked.
   • Embed this notice
     BowserNoodle ☦️ (bowsacnoodle@poa.st)'s status on Wednesday, 25-Dec-2024 06:32:33 JST BowserNoodle ☦️

     in reply to

     • DurpState
     • EnnaComa
     @givenup @EnnaComa @DurpState You should rebuild it then. DIY it. That's an incredibly good skill and you have the time. You can make good side money doing it.
   • Embed this notice
     EnnaComa (ennacoma@poa.st)'s status on Wednesday, 25-Dec-2024 06:32:34 JST EnnaComa

     in reply to

     • BowserNoodle ☦️
     • DurpState
     @BowsacNoodle @givenup @DurpState it's unbelievable what new fluid can do. I can name two times when I thought my truck was fucked to the tune of thousands of dollars, but a coolant flush one time and flushing the brake fluid the other time fixed it.
     Watch some YT videos and you'll get it.
   • Embed this notice
     BowserNoodle ☦️ (bowsacnoodle@poa.st)'s status on Wednesday, 25-Dec-2024 06:51:01 JST BowserNoodle ☦️

     in reply to

     • DurpState
     • EnnaComa
     @givenup @EnnaComa @DurpState Skill issue.
   • Embed this notice
     givenup (givenup@poa.st)'s status on Wednesday, 25-Dec-2024 06:51:02 JST givenup

     in reply to

     • BowserNoodle ☦️
     • DurpState
     • EnnaComa
     @BowsacNoodle @EnnaComa @DurpState well, i'm not rebuilding an autmatic transmission, i have no fucking idea.
   • Embed this notice
     givenup (givenup@poa.st)'s status on Wednesday, 25-Dec-2024 06:51:02 JST givenup

     in reply to

     • BowserNoodle ☦️
     • DurpState
     • EnnaComa
     @BowsacNoodle @EnnaComa @DurpState coupled with the fact i'd start a project that literally puts my vehicle out of comission until completion with no knowledge how to do it at all, it's not a good idea.
     BowserNoodle ☦️ likes this.
   • Embed this notice
     BowserNoodle ☦️ (bowsacnoodle@poa.st)'s status on Wednesday, 25-Dec-2024 07:41:35 JST BowserNoodle ☦️

     in reply to

     • DurpState
     • EnnaComa
     @givenup @EnnaComa @DurpState It actually doesn't take as much time to learn as you'd expect. YouTube is very handy for this sort of thing. You'd have to want to do it or have the interest though.
   • Embed this notice
     givenup (givenup@poa.st)'s status on Wednesday, 25-Dec-2024 07:41:36 JST givenup

     in reply to

     • BowserNoodle ☦️
     • DurpState
     • EnnaComa
     @BowsacNoodle @EnnaComa @DurpState yea no shit, it's not a porject that would take a few hours to even learn and you can't just jump in without knowing anything.
   • Embed this notice
     Tyler (tyler@nicecrew.digital)'s status on Wednesday, 25-Dec-2024 08:44:10 JST Tyler

     in reply to

     • BowserNoodle ☦️
     • DurpState
     • EnnaComa
     I'm finna trust a Temu lift nigga
   • Embed this notice
     BowserNoodle ☦️ (bowsacnoodle@poa.st)'s status on Wednesday, 25-Dec-2024 08:44:10 JST BowserNoodle ☦️

     in reply to

     • DurpState
     • Tyler
     • EnnaComa
     @tyler @DurpState @EnnaComa @givenup I would do a pit if I were you. Way safer and you already have experience building pits.
   • Embed this notice
     EnnaComa (ennacoma@poa.st)'s status on Wednesday, 25-Dec-2024 08:44:11 JST EnnaComa

     in reply to

     • BowserNoodle ☦️
     • DurpState
     @BowsacNoodle @givenup @DurpState yeah it goes quick if your a mechanical mage. Especially working in the driveway, with no lift, with a basic bitch socket set.
     I can turn a simple brake pad job into 8 hours.
   • Embed this notice
     Tyler (tyler@nicecrew.digital)'s status on Wednesday, 25-Dec-2024 12:24:37 JST Tyler

     in reply to

     • BowserNoodle ☦️
     • DurpState
     • EnnaComa
     Guess I'd need to get a concrete saw
   • Embed this notice
     BowserNoodle ☦️ (bowsacnoodle@poa.st)'s status on Wednesday, 25-Dec-2024 12:24:37 JST BowserNoodle ☦️

     in reply to

     • DurpState
     • Tyler
     • EnnaComa
     @tyler @DurpState @EnnaComa @givenup Just a blade, right? It's a painful time digging out concrete. Maybe building a new pit instead of digging out an existing garage makes more sense...
   • Embed this notice
     Tyler (tyler@nicecrew.digital)'s status on Wednesday, 25-Dec-2024 12:41:33 JST Tyler

     in reply to

     • BowserNoodle ☦️
     • DurpState
     • EnnaComa
     It rains here. A lot :)
   • Embed this notice
     BowserNoodle ☦️ (bowsacnoodle@poa.st)'s status on Wednesday, 25-Dec-2024 12:41:33 JST BowserNoodle ☦️

     in reply to

     • DurpState
     • Tyler
     • EnnaComa
     @tyler @DurpState @EnnaComa @givenup temu lift it is, yes? At least hydraulics seldom suffer catastrophic failure. It's more the welds I'd worry about.
   • Embed this notice
     BowserNoodle ☦️ (bowsacnoodle@poa.st)'s status on Wednesday, 25-Dec-2024 13:25:52 JST BowserNoodle ☦️

     in reply to

     • DurpState
     • Tyler
     • EnnaComa
     @tyler @DurpState @EnnaComa @givenup Thats extra. The paint hides their sloppy welds.
   • Embed this notice
     Tyler (tyler@nicecrew.digital)'s status on Wednesday, 25-Dec-2024 13:25:54 JST Tyler

     in reply to

     • BowserNoodle ☦️
     • DurpState
     • EnnaComa
     I'll go over all of them with 6010 then 7018
     
     maybe they'll give me a discount if I tell them I want it unpainted