Quixoticgeek@dalias Yep, that's what I'm doing. The problem is cos the body of the print has a curve to it, there's a small bit of support filament on each layer, So there's a lot of filament changes. The support filament from bambu isn't soluble, so this is ust to mske it easier to remove.
GNU social JP is a social network, courtesy of GNU social JP管理人. It runs on GNU social, version 2.0.2-dev, available under the GNU Affero General Public License.
All GNU social JP content and data are available under the Creative Commons Attribution 3.0 license.