After putting the preform in the fixture (ball side up) all I need to do is smear flux evenly across the lands on the package (no photos since my gloves were all sticky) and put the FPGA on top.
Then off to the oven.
After putting the preform in the fixture (ball side up) all I need to do is smear flux evenly across the lands on the package (no photos since my gloves were all sticky) and put the FPGA on top.
Then off to the oven.
GNU social JP is a social network, courtesy of GNU social JP管理人. It runs on GNU social, version 2.0.2-dev, available under the GNU Affero General Public License.
All GNU social JP content and data are available under the Creative Commons Attribution 3.0 license.