Conversation

Notices

1. Embed this notice
   LisPi (lispi314@udongein.xyz)'s status on Monday, 18-May-2026 12:15:23 JST LisPi
   Is there some way to have Wireguard peers discover eachother without either explicitly having an Endpoint configuration?
   • Embed this notice
     Rich Felker (dalias@hachyderm.io)'s status on Monday, 18-May-2026 12:15:21 JST Rich Felker

     in reply to

     @lispi314 Without layering other tooling to do that, no. You could probably script one of them to discover the other.

     What sort of topology are you trying to set up? I might have ideas for other ways to make something work.

   • Embed this notice
     Rich Felker (dalias@hachyderm.io)'s status on Monday, 18-May-2026 12:21:55 JST Rich Felker

     in reply to

     @lispi314 Do you have v6 you can run the wg tunnel over?

   • Embed this notice
     LisPi (lispi314@udongein.xyz)'s status on Monday, 18-May-2026 12:21:57 JST LisPi

     in reply to

     • Rich Felker
     @dalias At the moment, there's NAT-ing & an ipv4 subnet involved.
     
     I eventually intend to remove that. I would've liked for my current/imminent configuration to require no future adjustment when I finally did so.
     
     I *could* use another peer as a relay but I'm trying to give the phone access to as little as possible, so it has only a point-to-point Wireguard network definition.