Conversation

Notices

1. Embed this notice
   受不了包 (shibao@misskey.bubbletea.dev)'s status on Monday, 01-Sep-2025 01:42:01 JST 受不了包

   hello guys i will have free access to a 15,000 dollar cnc plasma cutter table but idk what to make does anyone have any ideas thx

   • Embed this notice
     受不了包 (shibao@misskey.bubbletea.dev)'s status on Monday, 01-Sep-2025 02:02:24 JST 受不了包

     in reply to

     usually i have lots of ideas but i think im neck deep in too many other projects right now to randomly have them for the plasma cutter

   • Embed this notice
     T man :sex: :puffgiga: :puffpowerroll: (theorytoe@ak.kyaruc.moe)'s status on Monday, 01-Sep-2025 02:03:08 JST T man :sex: :puffgiga: :puffpowerroll:

     in reply to
     @shibao im jealous
   • Embed this notice
     受不了包 (shibao@misskey.bubbletea.dev)'s status on Monday, 01-Sep-2025 02:03:46 JST 受不了包

     in reply to

     • Evelyn fra denne andre øya

     @evelyn i was thinking of making a little train that would be one side a vertical steel sheet with small rectangles cut out for a rack and pinion, and flat on the other side, but i dont have any good uses for such a small train thing

   • Embed this notice
     Evelyn fra denne andre øya (evelyn@misskey.bubbletea.dev)'s status on Monday, 01-Sep-2025 02:03:47 JST Evelyn fra denne andre øya

     in reply to

     @shibao rail section outlines

   • Embed this notice
     受不了包 (shibao@misskey.bubbletea.dev)'s status on Monday, 01-Sep-2025 10:33:12 JST 受不了包

     in reply to

     • whyrlpool

     @whyrlpool@slime.global i believe i have access to one as well. however i don't have any need for a pc case, in fact i have a micro itx one that i need to scrap actually

   • Embed this notice
     whyrlpool (whyrlpool@slime.global)'s status on Monday, 01-Sep-2025 10:33:13 JST whyrlpool

     in reply to

     @shibao a mess, and just get to grips with it
     If you also have access to a press brake you could make a pc case