Conversation

Notices

1. Embed this notice
   Josh Bressers (joshbressers@infosec.exchange)'s status on Saturday, 23-Nov-2024 13:21:35 JST Josh Bressers

   Tonight’s project was connecting a #Meshtastic node to a raspberry pi zero using GPIO

   The 4 pins I needed almost lined up exactly, which was nice

   Now it’ll run the BBS I’m working on
   https://github.com/joshbressers/meshbbs

   • Embed this notice
     kurtseifried (he/him) (kurtseifried@infosec.exchange)'s status on Saturday, 23-Nov-2024 14:36:33 JST kurtseifried (he/him)

     in reply to

     @joshbressers make sure it has the transcripts in the text files.

   • Embed this notice
     Josh Bressers (joshbressers@infosec.exchange)'s status on Sunday, 24-Nov-2024 23:16:39 JST Josh Bressers

     in reply to

     • osmodia

     @osmodia I'll try to write this down nicely at some point in the future

     I have GND, 5v, and tx/rx connected between the pi and Heltec

     Then you have to configure the pi to enable the serial port (I used raspi-config)

     Then you can tell meshtastic or the bbs to use /dev/ttyS0 as the serial port (this port isn't tried by default for anything it seems)

   • Embed this notice
     osmodia (osmodia@chaos.social)'s status on Sunday, 24-Nov-2024 23:16:40 JST osmodia

     in reply to

     @joshbressers How does this work? You're using TX/RX Pins from the Heltec, right? What do I need to configure in Meshtastic and how to configure Tc2-BBS?