Untitled attachment

Notices where this attachment appears

1. Embed this notice
   Dekks (dekks@social.vivaldi.net)'s status on Friday, 27-Dec-2024 11:12:11 JST Dekks

   in reply to

   @ntnsndr

   i get that feeling too, but until 5 or 6 years ago i only used it for org-mode & 1 or 2 minor prog modes.

   there is so much to #emacs that it's easy to feel inadequate but identifying what package would improve your work flow isn't the easiest thing to do.

   it's only in the last year that i've started to use use-package & that was due to one of Prot's videos actually showing me what it actually does.

2. Embed this notice
   Graham Sutherland / Polynomial (gsuberland@chaos.social)'s status on Friday, 06-Sep-2024 13:56:50 JST Graham Sutherland / Polynomial

   in reply to

   @greg for the same reason, capacitor manufacturers tend to do failure analysis by physically cutting the part out of the board, rather than desoldering it. the heat would alter the lattice and mess up any measurements or crystallographic analysis they want to do.

   it's also why you shouldn't run calibration on test equipment immediately after doing hot air rework. best to wait a few days for the initial rapid capacitance decline to settle down.

3. Embed this notice
   🇺🇦 haxadecimal (brouhaha@mastodon.social)'s status on Friday, 05-Apr-2024 18:26:40 JST 🇺🇦 haxadecimal

   in reply to

   @freemo @lowqualityfacts If they should do.it by social pressure (which does exist), but don't, that is why I say they have some of the blame. I agree that government and society bear more of it.