a kuka pm6-600 servo drive on a table. mouse for scale.

Notices where this attachment appears

1. Embed this notice
   Elia :verifiedtrans: (elia@fedi.quiescent.nexus)'s status on Monday, 05-Feb-2024 11:06:38 JST Elia :verifiedtrans:

   in reply to

   ok, that went better than expected.

   now I need to figure out which one of the two spares I have is the working unit, and which is the very non-working one.

   the story: when I originally bought the robot, it came with one of the servo drive channels broken, reporting “torque limit exceeded” on its axis. it was, in fact, a faulty current transducer reporting exaggerated current readings. I bought two more of pm6-600, “condition unknown”, for cheap. then turned three broken units into two working and one very, very broken.