XCKU5P FFVA676 bottom side substrate image (mirrored left to right from original photo) with zone fills annotated
https://files.ioc.exchange/media_attachments/files/111/700/825/810/271/953/original/2a0e44830c8ecfb1.jpg
Bottom side substrate photo, mirrored so it lines up with the top-down view in the datasheet. Ball A1 in top left corner. Slightly overexposed on the top left but it'll do.
A few of the lands look to have small amounts of solder residue that I didn't quite clean off fully, so before I reball I'll inspect and possibly clean them up. Hard to tell exactly how much solder there is in this lighting.
There's also a scratch in the soldermask around the T-U 12-13 region. Shouldn't be a big problem but I might try to touch it up just to make sure I don't get any problems.
The substrate matches the ballout perfectly (further evidence the chip is real) although there are a few interesting things:
* The GTY refclks don't have ground plane cutouts around them for impedance matching, only the high speed SERDES
* There's a tiny single-pin ground island next to the VCCAUX_IO island. Why not just fill with VCCINT there?
* Most interestingly, the VCCO zone fills don't line up with the IO banks!
GNU social JP is a social network, courtesy of GNU social JP管理人. It runs on GNU social, version 2.0.2-dev, available under the GNU Affero General Public License.
All GNU social JP content and data are available under the Creative Commons Attribution 3.0 license.