Notices by Schaf (schaf@netzkms.de)

@chybnej @fribbledom you would fill the whole space in between the parts, instead of bending it, or is there some trick i missed?

@fribbledom i think theres no way to do sheetmetal work naturally in openscad. what you can do is something like this:
• left part: intersect the piece with a cube the size of the part and length l to the start of the bending line minus r*alpha[radians]
• right part: same but on the other side, translate, rotate, -translate using the bending center
• middle part: on position "l", you create a projection and rotate_extrude it

@puniko Hui, heise ist echt clickbaitig geworden.

@evawolfangel Was wir wollen:
Transparenz bei CumEx
Intransparenz bei WebEx

Was wir bekommen:
Transparenz bei WebEx
Intransparenz bei CumEx