Notes:
* I scaled up the tank holder by 7% because it was a smidge loose on both the mounting peg and the wedges that hold the tanks when I printed them at 1:1 yesterday - this time they ended up much better
* The gun barrel is a bit tragic as it had heavy supports (I used heavy on everything today) and they were hard to pull off and the barrel bent a smidge
* The other side of the gun body is... Awful, as that was the supported side.
Embed Notice
HTML Code
Corresponding Notice
- Embed this notice
:trebuchet: Kale :trebuchet: (darkestkale@mastodon.social)'s status on Thursday, 20-Jun-2024 23:08:46 JST:trebuchet: Kale :trebuchet: