Yes, I think this just might work. There might be just enough room to solder the two PCBs together, using tiny castellated holes on the edge of the LED PCB.
I think it'd require removing and desoldering the programming header pins from the TinyLily, or at least trimming them very flush.
Could cut/sand the castellated holes through the TinyLily PCB if you actually wanted to try using tiny screws on the edge to mount this to something.
Embed Notice
HTML Code
Corresponding Notice
- Embed this notice
Jason Coon (jasoncoon@leds.social)'s status on Friday, 15-Mar-2024 06:59:25 JST Jason Coon