Emily VelascoI might have a little bit of a problem here. The thermocouple I have is not of the correct type for this controller, so the temperature it reads is wrong, which would be fine because I can see what the actual temperature is, but it looks like I cannot adjust the internal temperature of the box to be much lower than about 50C, which is 10 degrees too warm for making natto
GNU social JP is a social network, courtesy of GNU social JP管理人. It runs on GNU social, version 2.0.2-dev, available under the GNU Affero General Public License.
All GNU social JP content and data are available under the Creative Commons Attribution 3.0 license.