Conversation

Notices

1. Embed this notice
   恵真 :hypercat: (emma@niscii.xyz)'s status on Friday, 23-May-2025 20:43:25 JST 恵真 :hypercat:

   changed into brand new coil and now the vape is crackling. it wasn't doing that on the previous coil :akko_badday:

   • :ihavenomouth: likes this.
   • Embed this notice
     :ihavenomouth: (inginsub@clubcyberia.co)'s status on Friday, 23-May-2025 20:45:41 JST :ihavenomouth:

     in reply to
     @emma do you mean when it was new too? sometimes it happens because the coil is too clean and the juice is overheating
   • Embed this notice
     恵真 :hypercat: (emma@niscii.xyz)'s status on Friday, 23-May-2025 20:52:56 JST 恵真 :hypercat:

     in reply to

     • :ihavenomouth:

     @Inginsub@clubcyberia.co i was on a 0.4ohm coil at like 42w. this new one is i think 0.15 and it suggests 75w minimum which feels much warmer so it's probably like you say with overheating. is it safe to run much lower wattage than recommended for the coil? i do prefer the cooler sensation with the minty juices

     :ihavenomouth: likes this.
   • Embed this notice
     :ihavenomouth: (inginsub@clubcyberia.co)'s status on Friday, 23-May-2025 20:55:02 JST :ihavenomouth:

     in reply to
     @emma lower than recommended is safe, higher may be unsafe
   • Embed this notice
     恵真 :hypercat: (emma@niscii.xyz)'s status on Friday, 23-May-2025 21:32:04 JST 恵真 :hypercat:

     in reply to

     • :ihavenomouth:

     @Inginsub@clubcyberia.co good to know, thx
     it's still a bit crackly but not nearly as much popping and it feels nicer
     
     i think i will go back to 0.4 next time

     :ihavenomouth: likes this.
   • Embed this notice
     :ihavenomouth: (inginsub@clubcyberia.co)'s status on Friday, 23-May-2025 21:35:16 JST :ihavenomouth:

     in reply to
     @emma it’s going to crackle for a bit, overheating means it heats up above boiling point and explodes, it will stop when enough impurities accumulate on the coil and the wick. it happens randomly with some types of wire