Conversation

Notices

1. Embed this notice
   GeekMomProjects (geekmomprojects@mastodon.social)'s status on Thursday, 16-Jan-2025 17:37:16 JST GeekMomProjects

   I made a PCB icosahedron for a #makergiftexchange, learning a lot in the process. I wanted it to be see-through, so the sides have triangular holes containing etched acrylic pieces illuminated at the corners. Laser cut faux leather covers the outside. A #Pixelblaze controls the patterns.

   • Embed this notice
     valhalla (valhalla@social.gl-como.it)'s status on Thursday, 16-Jan-2025 17:37:16 JST valhalla

     in reply to
     @geekmomprojects shiny!
   • Embed this notice
     GeekMomProjects (geekmomprojects@mastodon.social)'s status on Friday, 17-Jan-2025 15:55:11 JST GeekMomProjects

     in reply to

     • fabrixxm

     @fabrixxm it would have been easier to assemble if it were!

     valhalla likes this.
   • Embed this notice
     fabrixxm (fabrixxm@social.gl-como.it)'s status on Friday, 17-Jan-2025 15:55:13 JST fabrixxm

     in reply to
     @geekmomprojects is it bigger on the inside?