Conversation

Notices

1. Embed this notice
   Mauricio Teixeira 🇧🇷🇺🇲 (badnetmask@hachyderm.io)'s status on Saturday, 02-Nov-2024 04:57:02 JST Mauricio Teixeira 🇧🇷🇺🇲

   Ugh. I've been fighting a PLA spool that insists in getting tangled at random lengths.

   Would someone know if this is "fixable" by drying out the filament, or is it just bad manufacturing and I need to re-spool?

   #3DPrinting

   • Embed this notice
     Mauricio Teixeira 🇧🇷🇺🇲 (badnetmask@hachyderm.io)'s status on Saturday, 02-Nov-2024 05:05:45 JST Mauricio Teixeira 🇧🇷🇺🇲

     in reply to

     • Kenneth Henderick

     @khenderick
     Ugh, I kind of expected that, but didn't hurt asking. Thanks.

   • Embed this notice
     Kenneth Henderick (khenderick@fosstodon.org)'s status on Saturday, 02-Nov-2024 05:05:46 JST Kenneth Henderick

     in reply to

     @badnetmask Just respool 👍

   • Embed this notice
     Mauricio Teixeira 🇧🇷🇺🇲 (badnetmask@hachyderm.io)'s status on Saturday, 23-Nov-2024 07:27:16 JST Mauricio Teixeira 🇧🇷🇺🇲

     in reply to

     So it did happen: the first time I had an actual problem with my Bambu X1C printer.

     Sadly it was partially my fault: I had this filament that kept getting tangled, I respooled it and was able to print, but eventually it broke inside the AMS.

     I thought it was a simple "oh it broke in the tubes", but no, it was actually broken inside the AMS *motor*, so I had a really hard time working on it.

     Well, I'm glad that Bambu Lab has great videos and documentation.

     #3DPrinting #BambuLab

   • Embed this notice
     Mauricio Teixeira 🇧🇷🇺🇲 (badnetmask@hachyderm.io)'s status on Sunday, 24-Nov-2024 08:52:30 JST Mauricio Teixeira 🇧🇷🇺🇲

     in reply to

     • Alex Kretzschmar

     @ironicbadger
     It was easier than I expected. They really made it simple to self-service.

   • Embed this notice
     Alex Kretzschmar (ironicbadger@techhub.social)'s status on Sunday, 24-Nov-2024 08:52:31 JST Alex Kretzschmar

     in reply to

     @badnetmask you get it taken care of ok?