Conversation

Notices

1. Embed this notice
   SlicerDicer (slicerdicer@bikeshed.party)'s status on Sunday, 22-Sep-2024 03:42:54 JST SlicerDicer
   So your lulzbot blows a fuse as it went nuts. You replace it with a terminal block.
   • Christmas Sun likes this.
   • Embed this notice
     SlicerDicer (slicerdicer@bikeshed.party)'s status on Sunday, 22-Sep-2024 03:52:52 JST SlicerDicer

     in reply to
     So in the land of real nerddom that’s the best kind of BDSM dom. I got a thermistor and I’m not afraid to use it.
     
     I had spare 100k thermistors that matched the one in the 3D printer so I replaced it, soldered it in and now I have a working 3D printer again.
     Another Linux Walt Alt likes this.
   • Embed this notice
     SlicerDicer (slicerdicer@bikeshed.party)'s status on Sunday, 22-Sep-2024 03:52:54 JST SlicerDicer

     in reply to
     So validated the board was not fried. Sweet. This is good stuff. Now to make the thing work.
     
     Slap chop time.
   • Embed this notice
     SlicerDicer (slicerdicer@bikeshed.party)'s status on Sunday, 22-Sep-2024 03:52:54 JST SlicerDicer

     in reply to
     So replaced the gear while I was at it. Then put a Napa in inline fuse in there. Close to operation at this point.