3Dプリンター買っていい?いいよ、いいよあり
Conversation
Notices
-
Embed this notice
机バンナー (desk_crusher@handon.club)'s status on Friday, 05-Aug-2022 20:59:23 JST 机バンナー
-
Embed this notice
雁木丸 (gangimaru@wndp.cloud)'s status on Friday, 05-Aug-2022 20:59:23 JST 雁木丸
@desk_crusher@handon.club どこの買うんです?
-
Embed this notice
机バンナー (desk_crusher@handon.club)'s status on Friday, 05-Aug-2022 21:01:43 JST 机バンナー
@Gangimaru Flash Forgeかな~と考えておりますが
-
Embed this notice
雁木丸 (gangimaru@wndp.cloud)'s status on Friday, 05-Aug-2022 21:01:43 JST 雁木丸
@desk_crusher@handon.club いいですね、ABSなんかは造形中に冷えて反ったりするんでケースになってる方が成功率上がりますよ。
-
Embed this notice
机バンナー (desk_crusher@handon.club)'s status on Friday, 05-Aug-2022 21:07:43 JST 机バンナー
@Gangimaru ちょっと金出せばノズル2つで可溶性サポート材出しながら積層できるんで良いんですよね
-
Embed this notice
雁木丸 (gangimaru@wndp.cloud)'s status on Friday, 05-Aug-2022 21:07:43 JST 雁木丸
@desk_crusher@handon.club デュアルヘッドの下位モデルとシングルヘッドの上位モデルが大体同じ値段なんですね。デュアルヘッドだとサポート気軽に使えるようになっていいでしょうねー。
-
Embed this notice