Conversation

Notices

1. Embed this notice
   Account: Firearms (gat@mu.zaitcev.nu)'s status on Wednesday, 24-Jan-2024 07:46:11 JST Account: Firearms
   I understand now why everyone is so obsessed with organic supports. The weight of the print went from 50g to 37g. That's a quarter less filament!
   
   #3dprint
   • narcolepsy and alcoholism :flag: and 受不了包 like this.
   • Embed this notice
     narcolepsy and alcoholism :flag: (hj@shigusegubu.club)'s status on Wednesday, 24-Jan-2024 07:48:26 JST narcolepsy and alcoholism :flag:

     in reply to
     @gat it's carbage for less geometric prints as it makes it hard to distinguish between support and model.
   • Embed this notice
     narcolepsy and alcoholism :flag: (hj@shigusegubu.club)'s status on Wednesday, 24-Jan-2024 08:05:42 JST narcolepsy and alcoholism :flag:

     in reply to
     @gat they tend to stick for me, especially in crevices
   • Embed this notice
     Account: Firearms (gat@mu.zaitcev.nu)'s status on Wednesday, 24-Jan-2024 08:05:44 JST Account: Firearms

     in reply to

     • narcolepsy and alcoholism :flag:
     @hj Yeah but if they don't stick to the print, then you should be able to peel them off by hand. For some of the more convoluted prints, I upped the horizontal distance to 120% of shell.