GNU social JP
  • FAQ
  • Login
GNU social JPは日本のGNU socialサーバーです。
Usage/ToS/admin/test/Pleroma FE
  • Public

    • Public
    • Network
    • Groups
    • Featured
    • Popular
    • People

Conversation

Notices

  1. Embed this notice
    Polychrome :blabcat: (polychrome@poly.cybre.city)'s status on Saturday, 17-Jun-2023 18:41:31 JST Polychrome :blabcat: Polychrome :blabcat:
    The PLA and 3D printer documentation says it needs to be at 200-210c but it leaks and strings horribly if I don't put it at 180c which seems potentially low :blobcatthonking:

    #3dprinting
    In conversation Saturday, 17-Jun-2023 18:41:31 JST from poly.cybre.city permalink
    • Embed this notice
      Polychrome :blabcat: (polychrome@poly.cybre.city)'s status on Saturday, 17-Jun-2023 19:21:24 JST Polychrome :blabcat: Polychrome :blabcat:
      in reply to
      • DeFrisselle ☑️
      @defrisselle Prusa Mini, using Prusament PLA.
      In conversation Saturday, 17-Jun-2023 19:21:24 JST permalink
    • Embed this notice
      DeFrisselle ☑️ (defrisselle@mastodon.sdf.org)'s status on Saturday, 17-Jun-2023 19:21:25 JST DeFrisselle ☑️ DeFrisselle ☑️
      in reply to

      @Polychrome

      What brand and type That is on the low end of the temp range Might get some clogging

      In conversation Saturday, 17-Jun-2023 19:21:25 JST permalink
    • Embed this notice
      DeFrisselle ☑️ (defrisselle@mastodon.sdf.org)'s status on Saturday, 17-Jun-2023 20:16:19 JST DeFrisselle ☑️ DeFrisselle ☑️
      in reply to

      @Polychrome

      Might not be dry or dry enough

      In conversation Saturday, 17-Jun-2023 20:16:19 JST permalink
    • Embed this notice
      socketwench (socketwench@hackers.town)'s status on Saturday, 17-Jun-2023 21:12:45 JST socketwench socketwench
      in reply to

      @Polychrome That happens to me a lot. Usually I only take the factory temperature as a starting point and use temperature towers to dial it in per printer. It can even vary between colors of the same material.

      In conversation Saturday, 17-Jun-2023 21:12:45 JST permalink
      Polychrome :blabcat: likes this.

Feeds

  • Activity Streams
  • RSS 2.0
  • Atom
  • Help
  • About
  • FAQ
  • TOS
  • Privacy
  • Source
  • Version
  • Contact

GNU social JP is a social network, courtesy of GNU social JP管理人. It runs on GNU social, version 2.0.2-dev, available under the GNU Affero General Public License.

Creative Commons Attribution 3.0 All GNU social JP content and data are available under the Creative Commons Attribution 3.0 license.