rear bike wheel hub showing the non-drive-side with brake rotor, lock ring capturing the rotor, and hub end protruding up above the lockring

Notices where this attachment appears

1. Embed this notice
   Jon Dubovsky (jond@mastodon.social)'s status on Sunday, 05-Mar-2023 06:42:19 JST Jon Dubovsky

   Home machining to the rescue!

   We've a #bike brake rotor lockring that's too thin for my old 16-notch BBT-19 (built for an era when it just had to worry about bottom brackets, not super-thin lockrings) and has too much axle protruding for my BBT-69.3 (socket isn't deep enough).

   There's a ton of meat in the BBT-69.3, so I just fixtured it and milled out the innards. 1. I should've done this on the SB-9 but it's currently offline; 2. I don't have a 20 mm end mill so had to make a circle by hand.