An assembled Xol toolhead, using the MeowXol faceplate, without any non-printed components, viewed from an angle and slightly above. The toolhead is mostly red, with a black extruder mount and a black paw on the faceplate.

Notices where this attachment appears

1. Embed this notice
   Koz Ross (koz@chaos.social)'s status on Monday, 17-Mar-2025 07:15:33 JST Koz Ross

   On the advice of @mia , and with the experience of @amd , I have decided to finally get Catboat-1 running again by rebuilding its toolhead. I'm going with the Xol, using the Tap carriage and the MeowXol faceplate. Now I have to order some parts (in transit now), but I can print the shell at least!

   Overall, _super_ impressed with the design of these parts, especially their supports.

   #3DPrinting #FDM @3dprinting