A 3D visualization of the board.

Notices where this attachment appears

1. Embed this notice
   blinry (blinry@chaos.social)'s status on Friday, 28-Feb-2025 21:18:30 JST blinry

   Back at my CO2 sensor project (an open-hardware Aranet 4 clone) this week! I finally made a PCB design – it's my first "complicated" design ever, so I feel very clumsy!

   Changes I still wanna make:

   - Flood the top layer with a ground fill, as well?
   - Add mounting holes.
   - Confirm correct placement of all parts in JLCPCB.
   - Add a cutout to allow the e-ink screen to be connected from the other side.

   If you have tips what mistakes to look out for at this stage, I'd be thankful!