Several ESD diodes missing solder paste

Notices where this attachment appears

1. Embed this notice
   Andrew Zonenberg (azonenberg@ioc.exchange)'s status on Saturday, 18-Jan-2025 02:13:38 JST Andrew Zonenberg

   in reply to

   Minor print defect in the very corner, probably insufficient paste at the edge of the array.

   Tried to tin the pads with an iron but the board had too much thermal mass. Couldn't use preheat or hot air because board was already pasted.

   I did the best I could, it'll probably bridge but I can fix it post reflow.