Untitled attachment

Notices where this attachment appears

1. Embed this notice
   Bernie (codewiz@mstdn.io)'s status on Wednesday, 01-Jan-2025 13:09:45 JST Bernie

   in reply to

   But I digress. I went to the Artisans Asylum with this rough #FreeCAD design to print it with one of the three Prusa MK3 available in the Digifab shop.

   A couple of nice people helped me setup various slicer parameters and the printer itself.

   A 0.10 mm fine print with common PLA filament takes about 40 minutes, and I had to iterate a couple of times to adjust the position of the screws, add scaffolding for the mounting screw hole on top, etc.

   #3dprint #retrocomputing #vintagecomputing