Untitled attachment

Notices where this attachment appears

1. Embed this notice
   gigabecquerel (gigabecquerel@chaos.social)'s status on Saturday, 30-Nov-2024 05:56:58 JST gigabecquerel

   in reply to

   Hmmmnice.
   It works as expected, and the kinematics reduce the mvement by a factor of ~3, so every Division moves the center by ~3 um.
   Should be just about ok, meaning that the piezo can do the rest of the Z travel.
   Issue is that I now need to constrain the ball on the micrometer, which means that I either have to grind a cup in the micrometer shaft or buy a different micrometer with a rounded tip to take the ball out entirely.

   ...maybe I should build a dremel tool mount for the lathe.