A photo of a truncated dome sitting on a bench. Behind it is the chassis of the volumetric display that it will eventually be mounted on.

Notices where this attachment appears

1. Embed this notice
   James Brown (ancientjames@mastodon.social)'s status on Friday, 15-Nov-2024 01:15:08 JST James Brown

   in reply to

   With the previous dome the cut had a somewhat hand made look to it, so I printed a thin piece of trim to slip over the edge and keep it neat. It was too big for the printer so I used TPU, printing it in a spiral and flexing it back in to the right diameter. An unexpected benefit was that it was way quieter with that isolating the dome from the base.
   This time the cut went better, but I’m still going to give it a gasket for that reason.