Untitled attachment

Notices where this attachment appears

1. Embed this notice
   raise-project (raise-project@mastodon.tech)'s status on Thursday, 17-Nov-2022 09:17:58 JST raise-project
   I havent really arrived yet even after 2 years now? Still sitting between SolveSpace and Freecad. Its even wirde for the cam side of things. Kiri:Moto is pretty nice and covers all the deep cuts for parts etc but had a hard time today to just get some carving going. I swear I just flipped the table two times. Lots of not so happy little accidents.
   
   In the end I just used the inbuilt gcode generation of Solvespace for the engraving. :D
   
   Leaving it like that probably as its just for me and I'm a very tolerant customer to myself.
   
   #solvespace #freecad #kirimoto #diycnc #semihollow #guitar #pickguard