Carbon fibre-filled flat support 5mm thick 230 mm long max 50mm wide 3D printed from carbon-fibre filled PLA. There are four mounting holes in a rectangle arrangement for an antenna feedhorn.

Notices where this attachment appears

1. Embed this notice
   Neil G4DBN (g4dbn@mastodon.radio)'s status on Wednesday, 19-Jun-2024 11:47:12 JST Neil G4DBN

   First attempt at a carbon-fibre-filled PLA support arm (one of a pair) for the milled-from-plate offset parabolic 122/134/248 GHz mmWave antenna dish. The left end attaches either side of a block bolted to the threaded holes behind the dish. The face is inclined at 18.9 degrees so points at the horizon with the bottom edge horizontal. The four mounting holes at the right end bolt to the enclosure containing the radar chip, focus rail, control electronics and feedhorn. Bit of Voronoi for bling.