Back side view showing rear panel connectors with red dust caps on ones not connected to anything

Notices where this attachment appears

1. Embed this notice
   Andrew Zonenberg (azonenberg@ioc.exchange)'s status on Saturday, 11-May-2024 03:51:15 JST Andrew Zonenberg

   in reply to

   And fully assembled!

   This was a nightmare. I'm never putting this much semirigid in such close quarters again. It was almost impossible to route.

   Me being conservative with some of the lengths thanks to not having access to pipe-routing MCAD software didn't help.

   But it worked, and it served its purpose of giving me real-project familiarity with panel design and semirigid. I doubt any of my future projects will need quite this density of ports going to a small area of board.