A Librem 5 wrapped in a red flexible plastic case, sitting on an Ender 5 3D printer next to three other empty case prototypes in red and grey.

Notices where this attachment appears

1. Embed this notice
   Kyle Rankin (kyle@mastodon.kylerank.in)'s status on Wednesday, 30-Aug-2023 21:45:24 JST Kyle Rankin

   Now that I have a printer that can print flexible filaments again, I've been able to try out a few TPU cases for my Librem 5 (I modified a Librem 5 slim model to remove most of the back). I tried printing face up and face down with supports to see what worked best for my printer.

   I think I'm leaning toward the red case, although I do have some old black Ninjaflex I might try out later.

   #3dprinting #Librem5